Go Down

Topic: Working on USA 120 volts (Read 5709 times) previous topic - next topic

benvolio9mm

I got my 10A power supply and plugged it in. No more resets. My printer is working now. I had a lot of fun building it. Next I will work on fine tuning and upgrades.

normoldboy

benvolio9mm
 
Congratulations !

You were right in your assessment of power  deficiency. I think that I will try and adapt an old computer power supply to act as a back up in case my supply acts up. I have been printing up a storm with the one that came with the kit, but it still makes the LEDs flicker when it is into a print job. It needs more "cow bells"

I just about finished printing out the white pieces of a chess set, and they all look very good.

Go Up