Go Down

Topic: How to tell if you damage I/O pin on the DUE? (Read 448 times) previous topic - next topic

PDK91

Jul 06, 2015, 10:11 pm Last Edit: Jul 06, 2015, 10:14 pm by PDK91
I recently realized that the radio module I was using outputs 5V signals from the Do/Di to my Rx/Tx. This radio module has been running for days, and is still running and working. I know the Arudino DUE is limited 3.3V for digital I/O pins, but does that include rx/tx pins too?

Is there a way for me to check if I damage by board or perhaps the rx/tx pins? Everything is working as it should but I want to know if this is going to be a problem.

Thanks


MarkT

You have exceeded its rating, it could easily be degraded and might fail totally in
the future.  Or it might not.  The only way is to test the device for years!
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

PDK91

Thanks for the reply. I guess I'll just have to wait and see!


Go Up