Pages: [1]   Go Down
Author Topic: Email and web server  (Read 640 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 13
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I am developing a system to connect to WiFi using a ConnectOne iWiFi Socket device - I just wonder if anyone has any experience with this - or any modem drivers?

This device is a serial to WiFi module, and has email client etc built-in.  I'm making a device to take in measurements from wireless and batteryless sensors using EnOcean STM 110 modules to monitor things like pond temperature, water flow and level and other sensors around the house, recieve them using an EnOcean TCM 120 connected to Arduino, then send email alerts using the ConnectOne module.

Biggest problem seems to be the fact I'll need two serial ports - one for the EnOcean receiver, and one for the WiFi module.  Any easy way of creating two 19,200bps serial ports on the board?
Logged

Copenhagen / Denmark
Offline Offline
Edison Member
*
Karma: 6
Posts: 2360
Do it !
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

check the soft serial example in the playground, for a way to have two serial lines at the same time
« Last Edit: December 02, 2007, 03:58:21 pm by MikMo » Logged

Brisbane, Australia
Offline Offline
God Member
*****
Karma: 1
Posts: 593
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Software serial is too slow for 19200.

The ATmega128 has two hardware serial ports.
Logged

New Zealand
Offline Offline
God Member
*****
Karma: 0
Posts: 999
Arduino pebbles
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
Any easy way of creating two 19,200bps serial ports on the board?
Would you need to use both at the same time? Could you get away with using one and switching which device is active?

--Phil.
Logged

Pages: [1]   Go Up
Jump to: