Pages: [1]   Go Down
Author Topic: Using arduino bootloader to load AVRStudio Code  (Read 635 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 23
The Roboduino Rocks!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello all,
I want to use the Arduino bootloader to upload code I've written in AVRlib( code is in C and does not use any Arduino libraries)

I'm talking about programming in AVRstudio with GCC using AVRlib  and uploading through the bootloader. Is there a special make file I have to use to accomplish this?

Thanks,
Eric
Logged

Check out the Roboduino Arduino-compatible board!


0
Offline Offline
Faraday Member
**
Karma: 16
Posts: 2855
ruggedcircuits.com
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

The bootloader is compatible with AVRDUDE so you can just take the HEX file you get with AVR Studio and pass it to AVRDUDE.

No special Makefile required.
Logged

Pages: [1]   Go Up
Jump to: