Pages: [1]   Go Down
Author Topic: Communicating with Arduino Bluetooth  (Read 678 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 1
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello, I have a quick question, on the Arduino Bluetooth, can apps for the Arduino send and receive commands over the RFCOMM/SPP Bluetooth profile? I was going for something that could make it so if a command is sent over RFCOMM/SPP from a Bluetooth device paired to the Arduino that a pin on the Arduino goes to high or low mode.

Would this be possible?

Thanks,
Aakash

EDIT: I guess this would also be asking if the Bluetooth chip is connected to the TX/RX pins of the Arduino's microcontroller.
« Last Edit: October 28, 2009, 06:40:25 pm by AakashPatel » Logged

Pages: [1]   Go Up
Jump to: