Go Down

Topic: Communicating with Arduino Bluetooth (Read 970 times) previous topic - next topic

Aakash Patel

Oct 29, 2009, 12:27 am Last Edit: Oct 29, 2009, 12:40 am by AakashPatel Reason: 1
Hello, I have a quick question, on the Arduino Bluetooth, can apps for the Arduino send and receive commands over the RFCOMM/SPP Bluetooth profile? I was going for something that could make it so if a command is sent over RFCOMM/SPP from a Bluetooth device paired to the Arduino that a pin on the Arduino goes to high or low mode.

Would this be possible?


EDIT: I guess this would also be asking if the Bluetooth chip is connected to the TX/RX pins of the Arduino's microcontroller.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131