Go Down

Topic: usb arduino + director + multiple push buttons (Read 1 time) previous topic - next topic



i am trying to connect the arduino board over usb to director.
i tried this code by wilson http://userwww.sfsu.edu/~infoarts/technical/arduino/wilsonserialIO.txt and i am using the serialXtra by geoff smith.

the examples work fine on the board, but somehow i get strange results inside director:
when i push the first button, which is connected to pin3, then i get director not to read the H (H for high, and L for low) - when i push the second button which is connected to pin4 then director reads an H at this location. if i now push BOTH buttons, then director reads also an H for pin 3.

as i have not so much idea about electricity flows (just started) here the image of the wiring, maybe there is something wrong ?
(i am using two 10kOhm resistors)

any help would be appriciated!

all the best


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131