Pages: [1]   Go Down
Author Topic: Xbee Series 1 and Arduino Mega  (Read 1351 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 41
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am trying to send packets from one arduino to another using the XBP24-AWI-001 modules and the libelium Xbee shields.  I need to send an array of latitude and longitude coordinates as packets.

I looked over the Arduino Xbee library and examples at http://code.google.com/p/xbee-arduino but I still need some direction.  

Also, how should the pins of the shield be connected if I don't want to use the Software Serial and have it on a breadboard and using the hardware serial pins?  What is the main benefit of using the shield?  Thanks.
Logged

Seattle, WA USA
Offline Offline
Brattain Member
*****
Karma: 654
Posts: 50931
Seattle, WA USA
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
What is the main benefit of using the shield?

Over using what? The XBees use non-breadboard-compatible pin spacing, so you need some sort of adapter. Also, the XBee is a 3.3V device. The shield manages the voltage drop for you. Finally, using the shield means you don't have to worry about how to connect the right pins together.

The XBee library looks pretty straightforward. The payload array is where you put your data. The uint8_t type is the same size as a char, so you could user char instead. You might need to do a cast later, but that's easy enough.

Use sprintf to write the data into the array:

Code:
sprintf(payload, "Lat: %f Long %f", lat, long); // Assuming lat and long are floats

Then, use strlen instead of sizeof to get the size of array for the 3rd argument for the ZbTxRequest constructor.
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 41
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

There are size constraints on the board, so I need to mount the xbee shield next to the arduino mega.  Also, I am connecting the GPS module and LED screen to the VCC and ground pins on the mega board and these pins are covered up by the shield.
Logged

Pages: [1]   Go Up
Jump to: