Pages: [1]   Go Down
Author Topic: Interfacing TPIC6C596N  (Read 916 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Sr. Member
****
Karma: 0
Posts: 250
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, i am intersting to use this shift register TPIC6C596N with arduino like common 595.

on the datasheet it says about these pins
RCK-register clock
CLR-shift register clear
SRCK-shift register clock
SER IN-serial input

shiftout uses these pins
clockPin
latchPin
dataPin

what pins do i need to connect to use shiftout command? and what is the different RCK and SRCK?

or better question how can i make this work with arduino?

edit:

i  was trying to understand and i think its ok:

SERIN=DATAPIN
SRCK=CLOCKPIN
RCK= LATCHPIN

CLEAR= it just clear the registers when it goes on low

is this correct?
« Last Edit: December 02, 2010, 05:20:55 pm by acmilangr » Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 627
Posts: 34246
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

The pinout is exactly the same it is just that they call the pin functions by different names. Just use the same pin numbers as you see in the tutorial.
Logged

0
Offline Offline
Sr. Member
****
Karma: 0
Posts: 250
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

not they are not the same

look
http://focus.ti.com/lit/ds/symlink/tpic6c596.pdf
http://www.arduino.cc/en/Tutorial/ShiftOut
Logged

0
Offline Offline
Sr. Member
****
Karma: 0
Posts: 250
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

any help please?
Logged

Pages: [1]   Go Up
Jump to: