Go Down

Topic: internal interrupts? (Read 3922 times) previous topic - next topic

Does anybody have any experience with/can anyone point me to some examples using internal interrupts?

I've seen the general examples with regard to turning on and off interrupts, but it would be nice if I could just have my function go off (say every 10ms) based on an internal interrupt.  Specifically, what I am looking at doing is developing a consistant, well defined integration period to generate position data from my gyro rate data.

P.S - (I am actually using a wiring board, but have found no luck on their forums, and was hoping that the similarity between the two boards might lead to a solution).

Thanks Everyone, in advance!

.jim


Daniel

see this post
http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1162726448

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy