Pages: [1]   Go Down
Author Topic: Serial.print  (Read 469 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 14
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Question, when I call a Serial.print or println where does it print to? I just got my board today and I'm playing around with the IDE learning how it all works. Thanks.
Logged

Florida, USA
Offline Offline
Full Member
***
Karma: 0
Posts: 146
meow!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

It prints to the serial port.  You can monitor this with the "Serial Monitor" built into the Arduino IDE (it's the rightmost of the buttons above the editor window).  You need to call Serial.begin(baudrate) before doing Serial.print().  Put that in your setup() function.  Then click on the Serial Monitor button and set the same baud rate.  Hope this helps...
Logged

Pages: [1]   Go Up
Jump to: