Go Down

Topic: microseconds (Read 404 times) previous topic - next topic


Is there a way to measure microseconds? I want to find out the interval between certain events (in this case, bytes received by the arduino) and milliseconds is a bit too crude.


There is not a call for measuring microseconds.
You could use delayMicroseconds() and polling to repeatedly wait a while and check to get a rough idea of how long it was.
You could also look at TCNT1 which is a 16 bit register that increments every 4 microseconds in the standard Arduino configuration. It is going to roll over frequently, and you really should block interrupts around reads to it, like this...
Code: [Select]
myVar = TCNT1;

... which assumes you know interrupts were off when you started. (true for normal Arduino code).

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131