Go Down

Topic: Serial communication to 2 outputs (Read 564 times) previous topic - next topic

Wimber

Jun 06, 2007, 04:44 pm Last Edit: Jun 06, 2007, 05:05 pm by Wim_Br Reason: 1
Hello all !

I have a little noobish newbie question



I've made a flash interface that communicates with the Arduino Board with the serialServer   - like in the screen above.
So far so good. By adjusting a slider in flash  I can modify the output voltage via PWM on digital output (10).

Now I want to modify another digital output (9) at the same time via serial communication. Is this possible?

Wim

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy