Pages: [1]   Go Down
Author Topic: Activating Pull-Up Resistor for Analog Ins  (Read 584 times)
0 Members and 1 Guest are viewing this topic.
www.tagtool.org
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino rocks Tagtool
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

How it´s possible to activate the internal pull-up resistors for the analog ins on an arduino ng board?

Any ideas?
cheers,
tagtool
Logged

0
Offline Offline
Full Member
***
Karma: 0
Posts: 203
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I haven't tried, but with arduino-0008 the analog ins also show up as digital14 through digital19. You should be able to do something like a digitalWrite(14,HIGH) to turn them on.
Logged

www.tagtool.org
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino rocks Tagtool
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

We also tried this but it didn´t work.

Would be nice to do it by software, then solder pull-up resistors onto the sliders.

We keep on trying ....

thx,
tagtool
Logged

www.tagtool.org
Offline Offline
Newbie
*
Karma: 0
Posts: 3
Arduino rocks Tagtool
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

HA!!!!
another day!!!

U right... with digital it works.


cheers m8,
tagtool
Logged

Pages: [1]   Go Up
Jump to: