Go Down

Topic: Error while burning bootloader. (Read 228 times) previous topic - next topic

TheMightyMolar

Im a newbie having an issue with my first project
I am having an issue uploading from the Arduino Uno to my board.

I followed these instructions. https://www.arduino.cc/en/Tutorial/ArduinoISP

Attached in Txt is the error and a resized photo of both.

The pins on a 2x3 header were matched however I did not understand this direction, and Im not sure if it meant ground and reset on the arduino or the board being programmed.
(Note for the Arduino Uno: you'll need to add a 10 uF capacitor between reset and ground.)

groundFungus

#1
Aug 06, 2016, 03:28 am Last Edit: Aug 06, 2016, 03:30 am by groundfungus
The cap goes between ground and reset on the Uno being used as the programmer.  Make sure to mind the polarity of the cap.

Go Up