Go Down

Topic: servo decoder/encoder (Read 931 times) previous topic - next topic


I am making a pcb for decoding 8 servo signal and then its supposed to encode8 servo signals. I also have added a tri color led to the pcb to tell me if the encoded signals is just a mirror of the decoded signals, or if it uses the values send over the serial line( or should i use i2c instead?). is this possible to do with the atmega 328?(does this chip have identical size to 168? Space is important... it looks like i will be able to just extend my receiver with 12mm)

I am bit worried about speed and that the chip might hang and then the whole plane will crash( Maybe i need to route out reset as well so an external component can restart it or? )

Do I also need a 16 mhz crystal? Or is the internal 8 mhz fast enough.

Does it exist 3 ways 90 degree headers both female and male on the market? or is 2 ways the largest?

any comments to these qustions?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131