Go Down

Topic: continuous servo limitations (Read 988 times) previous topic - next topic


Hello and thanks for checking out my post.

I'm relatively new to using the arduino and have no experience using a servo, so I was wondering if someone might be able to explain the limitations of using a continuous servo.  
The project that I'm starting will be raising and lowering an object attatched to a spool of thread attatched to the servo.  I'd like the user to


A couple of high level limitations:

Speed: Servos arn't fast...

Control: It's hard to control the servos. You dont actually know where the servo is. It'll be a case of gestimating travel.


Beware of stalling the motor in a servo.  Some servos have gears inside that can be damaged by stalling, and I think it'd be more likely to happen with a crane-type mechanism that you mentioned (when the load reaches the top).

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131