Pages: [1]   Go Down
Author Topic: Speakjet Disable "Ready"  (Read 4208 times)
0 Members and 1 Guest are viewing this topic.
Monterey CA
Offline Offline
Sr. Member
****
Karma: 1
Posts: 323
Addicted to Arduino
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Is there a way to stop the Speakjet from saying ready on power on? So I can have my own startup sound?

I have the Sparkfun voice shield with the TTS chip.

Thanks.
Logged

Current Projects:                    Arduinos:
Security Robot Tank               Uno
Security Robot II 4WD            Mega2560

http://mobilewill.blogspot.com

Van Alstyne, TX
Offline Offline
Full Member
***
Karma: 1
Posts: 154
Haven't smoked an Arduino... yet.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Look at page 11 of the SpeakJet User Manual, particularly EE memory location 237
which allows you to turn off the speech on power up or change the phrase spoken.

Unless you know what's exactly in the phrases in EE memory, it's probably just
easier to start overwriting it with your own phrases and set the "pointers" for
each phrase as you write them.

Edit: This is not something you want the Arduino doing everytime your app starts
up.  It's more like a one time config before putting the SpeakJet into the circuit.

     -Rusty-
« Last Edit: January 23, 2011, 05:15:28 pm by Fe2o3Fish » Logged

Monterey CA
Offline Offline
Sr. Member
****
Karma: 1
Posts: 323
Addicted to Arduino
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks, I thought I saw in the Manuel before but couldn't find it again. Should could I just set it to the sound codes?
Logged

Current Projects:                    Arduinos:
Security Robot Tank               Uno
Security Robot II 4WD            Mega2560

http://mobilewill.blogspot.com

Pages: [1]   Go Up
Jump to: