Go Down

Topic: Arduino Mega 2560 to Atmel ATMEGA328P-PU chip (Read 178 times) previous topic - next topic

mirandamg


Hi there,

I am using the Arduino Mega 2560 to develop code for my project. I don't need so many I/O pins and would like to translate this code onto a smaller chip (Atmel ATMEGA328P-PU) to plug into my breadboard. Is this possible? How do I do this?

Thanks in advance.


spycatcher2k

Just change the board type in the IDE & make sure you are using the correct pins. This is assuming your sketch fits in the UNO's flash and RAM
-=-
http://www.uk-pcb.co.uk - UK Based PCB Fab Company
I will code for you, but I will also charge you (PM me)
If you don't like my answers, realize : I'm not being cheeky, I'm Just trying to prompt you to use your own brain/google etc.

Go Up