Pages: [1]   Go Down
Author Topic: lcd setCursor() troubles with arduino17  (Read 379 times)
0 Members and 1 Guest are viewing this topic.
Chennai, India
Offline Offline
God Member
*****
Karma: 0
Posts: 752
Peace!!!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

In Arduino0017, the setCursor function fails to produce any display on the second line of a 16x2 LCD display both in 4-bit as well as 8-bit mode. However the same works in Arduino0013.

I would appreciate if someone can throw some light on this.
Logged

Be The Change...

Spokane, Washington
Offline Offline
God Member
*****
Karma: 1
Posts: 686
My name is Bob, and I'm an addict.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Could you post your code?

I noticed that upgrading from the previous versions, 0017 has an upgraded version of LiquidCrystal, so you need to do an lcd.begin(16, 2);  in your setup line.
Logged

Chennai, India
Offline Offline
God Member
*****
Karma: 0
Posts: 752
Peace!!!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks. Tried that and works fine now.
Logged

Be The Change...

Pages: [1]   Go Up
Jump to: