Go Down

Topic: X10 Doc Error? (Read 548 times) previous topic - next topic


I think there's an error in the schematic on the X10 Tutorial page

The pull-up resistor should be on the "zero-crossing" pin, not on the "data" pin.

I tried hooking things up the way it shows in the picture, and the example program didn't work (my lights didn't blink).

Then I thought about it a bit, and tried putting the resistor on the other pin.  Voila!  Flashing lights!

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131