Go Down

Topic: Exporting on OSX (Read 1 time) previous topic - next topic

mrbbp

#10
Nov 15, 2005, 09:48 pm Last Edit: Nov 15, 2005, 09:51 pm by mrbbp Reason: 1
problem resolved :) (thanks to gianluca from smartprojects.it)

the sv1 jumper was not at the rigth place.
have to be over the 2 pins near the usb...

now arduino upload the prog
Code: [Select]
Atmel AVR ATmega8 is found.
Uploading: flash
Firmware Version: 1.18
Firmware Version: 1.18


the ref pic for the sv1 jumper


regards

Go Up