Go Down

Topic: Exporting on OSX (Read 1 time) previous topic - next topic

mellis


boppyer

nice one :-) many thanks for that :-)

alain

Hello

I am having the same problem as Boppyer with my usb board, running os X on my ibook.
I am using arduino 002 and I have tried the different port speeds 9600 and 19200
and outputs
 /dev/tty.usbserial-3B1 /dev/cu.usbserial-3B1
but I always get the 'Programmer is not responding ' message when I try to export...

Any idea what I am doing wrong

Alain

alain

OK, never mind. I found it . I was just waiting for too long between restting and uploading...

Need to get a coffee   ;)

mrbbp

Hello...

same prob with osx and arduino0002.
"programmer not respond"

I've tried with the 2 serial port tty and cc.
i've tried resetting and launch upload (shortly after resetting)
I've changed the speed baud...

I've tried with card N°484 and 485, usb card.

Any Idea ?

I'm on Powerbook 1.67 with 10.4.2...
using rigth usb on the powerbook

regards

eric

Go Up