Go Down

Topic: stk500 sync error (Read 684 times) previous topic - next topic

syrax

when i urn bootloader for first time i have problem with stk500 protocol , sync error....

i found when burn my bootloader i must use 16Mhz crystal inserted to target  ,
becouse when i burn boot.... i use SKT500 programmer with own clock generator and this makes trouble for sketches after that for uploading sketches . when i put crystal on my skt500 i burn bootloader again everythink look fine

regards from bulgaria :))

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy