Pages: [1]   Go Down
Author Topic: Problem running nw sketch without bootloader  (Read 324 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 4
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey

I just made a arduino prototype on a bread board, interfacing it with software using STK200 parallel ISP. I did some configuration and was able to download it to chip successfully. Here comes the problem, the simple LED Blink sketch is not working at all I tried on different pins 13,25,26,27 connecting LED but nothing is glowing. smiley-razz

I use same parallel ISP (STK200) with CodeVisionAVR IDE and I am successfully uploading as well as running programms

Please help me in sorting out problem.....
Logged

Brazil
Offline Offline
Sr. Member
****
Karma: 0
Posts: 443
..., to learn, to know, to make, to share, to l...
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Arduino board Pin13 is not the same on IC.

Arduino board Pin13 is equivalent to IC pin 19.

I don't know if you considered this to use the blink sketch example, since you're not using the Arduino board.
Logged

PCB Designer

0
Offline Offline
Newbie
*
Karma: 0
Posts: 4
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks a lot Adilson..... I was connecting LED to wrong pin..... smiley
Logged

Pages: [1]   Go Up
Jump to: