Go Down

Topic: virtualWire bits per sec problem (Read 534 times) previous topic - next topic

Geek Ionizado

I'm using the virtualWire library to send some data but it works only at 2000 bits per sec, if I setup to 4800 (my 433.92 rf modules rate) it almost don't works, only send the signal so far away, and always lost signal. But with 2000bps I have a pretty good signal. The problem is that I have to use a delay(200); at the loop, If I don't use this I don't get any results. But this delay makes a slow responde, and I need to send data imediatelly, without delay.

Somebody knows what can be happening?

Thanks!!!  ::)

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy