Pages: [1]   Go Down
Author Topic: Atmega8-16AU  (Read 3587 times)
0 Members and 1 Guest are viewing this topic.
Gatineau, Qu
Offline Offline
Jr. Member
**
Karma: 1
Posts: 94
Did you Arduino today?
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm wanting to order some atmega8-16au (32 pin SMD)
Are they supported? Will the IDE work with them? Will optiboot work with them?

Please help! As you can tell I'm pretty GREEN!   smiley-red
Logged

Global Moderator
Boston area, metrowest
Online Online
Brattain Member
*****
Karma: 437
Posts: 23700
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Check the list here to start
http://www.avr-developers.com/
Logged

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

SF Bay Area (USA)
Offline Offline
Tesla Member
***
Karma: 106
Posts: 6371
Strongly opinionated, but not official!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

It should work the same as a non-SMT mega8.
You can put optiboot on a mega8, but you'll need to get a more recent version from the optiboot repository.
Logged

malaysia
Offline Offline
Full Member
***
Karma: 1
Posts: 101
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

im trying to burn the bootloder to my new atmega8 with arduino uno, but there had some problem occur..anyone nw hw to solve it?

Erro while burning bootloder
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51
Logged

dut eden rockes

Pages: [1]   Go Up
Jump to: