Pages: [1]   Go Down
Author Topic: FTDI win7 Problem  (Read 5039 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 9
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,

I've got some problems with my FTDI Cable(5V) and Diavolino (Duemilanove clone) on Windows 7 (64bit).
It installed fine automatically and there showed 2 (why 2?) COM Ports up. COM1 and COM4. COM4 is the TTL-to-serial adaptor.

Everything good until here. But as soon as I connect the arduino, it starts to blink its LED (maybe at 2Hz?) even though there is no blink skech on it.
When I start the arduino-IDE COM4 disappears and I hear the Windows "hardware changed" sound again and again.

The Diavolino and the cable work fine on my old G4 Powerbook (OSX10.5).
I already tried installing the drivers manually (from their website) and I tried setting "RTS-on-close", because I read that on some board not doing so causes trouble...

Any ideas?
~greeny
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 9
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Now I tried the 32-bit drivers as well as the 64-bit, but no change...
My Arduino is powered by external batteries, could this make any difference?
Logged

Forum Administrator
Cambridge, MA
Offline Offline
Faraday Member
*****
Karma: 12
Posts: 3538
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I would try asking EMSL (the makers of the Diavolino) for help. 
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 9
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yeah, I already did this here, but they sent me here to the arduino forum ;-)
Logged

Pages: [1]   Go Up
Jump to: