Also, if I want to make a direct USB connection without the large cable ends, is there any problem with soldering the cores (and shield) of the USB cable to the pins of the Arduino's connector?
and I can see 50Hz at various points in my circuit
There's too much for me to digest at once and I can't comment much on the analogue/PSU stuff, but a couple of things I'm not sure about .
1307 GND connected to VBAT, its that OK. The chip will expect a battery on that to work when power is cut.
The 18B20 temp sensor, doesn't that need a VDD/VCC connection?
Silly question, but are you sure the external PSU is DC?
R5, 6 and 7 add up to 460.6k. Given that they are in series with a pot couldn't you just use a 470k?Admittedly the pot is only 2k, do you need that fine adjustment?______Rob
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16