Go Down

Topic: Mega 2560 Solder Bridge (Read 2 times) previous topic - next topic

mikenon

I received my Mega today, and was alarmed to see the 5V and 3.3V pins joined with a solder bridge.

Is this common?

mmcp42

I suspect that is a bad thing that is very bad
what does supplier say?

a) demand new 1 with menaces
b) 2 seconds with wick or solder pump shoud fix it

worrying though
there are only 10 types of people
them that understands binary
and them that doesn't

mikenon

I'll have no problem removing the bridge, but I will always question whether there are other, less visible, errors with the board. SparkFun said "hope you know how to email or solder  :P " in IRC.

My main reason for posting here is to let people know about the problem. If it happens to one board, it's undoubtedly happened to others. Losing a $65 piece of hardware because you were so excited to load its first program that you neglected to check for errors is an awfully saddening thing.

Federico

Definitly a bad thing. I am really surprised! If it was mine, it was already broken. I am not used to chek everything ..
Federico - Sideralis
Arduino &C: http://www.sideralis.org
Foto: http://blackman.amicofigo.com

mowcius


I'll have no problem removing the bridge, but I will always question whether there are other, less visible, errors with the board. SparkFun said "hope you know how to email or solder  :P " in IRC.

My main reason for posting here is to let people know about the problem. If it happens to one board, it's undoubtedly happened to others. Losing a $65 piece of hardware because you were so excited to load its first program that you neglected to check for errors is an awfully saddening thing.

Unfortunately this has seemingly been pretty common with the new arduino boards.
Have a search around and you will no doubt see what I mean.

The Arduino team have stated that boards can be returned and a new one will be issued free of charge but that's probably not worth it in your case.

Mowcius

Go Up