Go Down

Topic: X10 Tutorial (Read 2902 times) previous topic - next topic


Jan 28, 2011, 05:46 am Last Edit: Jan 28, 2011, 05:48 am by benjamindees Reason: 1
The circuit diagram on the X10 tutorial is incorrect.  It does not work at all.


This has been discussed before:


The problems are as follows:

1) The Zero Crossing and Data lines are swapped.
2) The jack orientation is confusing and should be marked with pin numbers.

Here is a suggested replacement:

Also, the only X10 command example shown in the tutorial is the "ALL_LIGHTS_ON" command, which not all modules respond to.  Addressing a single module is not particularly intuitive.  An example of this could be added as well:

// Turns on module A1
myHouse.write(A, UNIT_1, 1);
myHouse.write(A, ON, 1);

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131