I have made http://www.arduino.cc/en/Main/Standalone
this one about 2 times used the exactly same materials ,second time changed the crystals as well as the caps couldn't find out why isn't its working on these, i then took up this http://hcgilje.wordpress.com/resources/arduino-standalone/
minimal arduino and made it on the PCB to ensure that its not my BreadBoard which is faulty but even on that PCB soldered with too much care but the system is not running,
i flashed my ATmega168 with the pro mini's 8Mhz ,3.3 v board type HEX file,to allow for the internal Oscillator's use by the CHIP.The program is a simple blink program to know that whether the whole setup is working or not.
also i used the 104 AEC
Capacitor 0.1 uf value and also the 820 ohm resistor instead of 1K.
LED on pin 13 (actual pin 19 on the ATmega168) is not Blinking!
Don't know where the problem could be?.
or,If any one of you can suggest a better one, over which you have made and that has worked successfully tell me about that?