Go Down

Topic: USB Host + Arduino + Unknown Video Board (Read 2539 times) previous topic - next topic


Hey all,

I have an old video board, it boots up and runs a projector. But I want to remove all the setup portion (you have to control it with a computer, I have the commands that need to be sent). There is a setup process where you change how bright the screen is and the resolution you need to run it at.

Anyway, when I connect this thing to my computer and sniff it, it is a CDC device. I use Hyperterminal to communicate with it, changing all the values I want. I would essentially like to simulate these commands with the Arduino. I have a USB-Host shield, but I would just like to make sure this will work before I attempt.



CDC device is not very difficult to implement, here is an example for FTDI232, which is quite similar -> http://www.circuitsathome.com/mcu/towards-an-ft232-driver-for-the-usb-host-shield-part-0

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131