Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: Interfacing with Paradox Spectra Security Systems  (Read 1612 times)
0 Members and 1 Guest are viewing this topic.
Mauzer
0
Offline Offline
Newbie
*
Karma: 0
Posts: 9
Arduino rocks
View Profile
« on: April 16, 2012, 11:45:36 am »
 Bigger Bigger Smaller Smaller Reset Reset
Hello,

Has anyone tried to decode Paradox Spectra Security Systems serial interface? My plan is to get activity reports via Spectra's serial interface with JeeNode. I connected my JeeNode to Spretra's serial interface and successfully managed to transfer serial data packets to JeeLink. But I need to decode this serial communication...  smiley-roll
Logged

Dene
0
Offline Offline
Newbie
*
Karma: 0
Posts: 9
Arduino rocks
View Profile
« Reply #1 on: July 18, 2012, 10:37:30 am »
 Bigger Bigger Smaller Smaller Reset Reset
I want to know how too
Logged

tincanman
Offline Offline
Newbie
*
Karma: 0
Posts: 28
View Profile
« Reply #2 on: August 23, 2012, 07:54:44 pm »
 Bigger Bigger Smaller Smaller Reset Reset
well, if you can successfully communicate with it via serial, then you should be able to grab the serial data. Determine the baud rate and you should be good to go.
Then try and see if there are any patterns in the data (meaning that it is a packet based communication).
Logged

John W
Cape Town
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
« Reply #3 on: September 19, 2012, 07:45:00 am »
 Bigger Bigger Smaller Smaller Reset Reset
Hi there, if you get the PRT3 module, you can have all the content sent to you over a serial bus, in either ascii or c-bus format.

http://www.paradox-alarm-systems.com/en/p/433/paradox-prt3-

regards
John
 smiley-grin
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: