Go Down

Topic: USB Host + Arduino + Unknown Video Board (Read 1 time) previous topic - next topic

Interesting

Hey all,

I have an old video board, it boots up and runs a projector. But I want to remove all the setup portion (you have to control it with a computer, I have the commands that need to be sent). There is a setup process where you change how bright the screen is and the resolution you need to run it at.

Anyway, when I connect this thing to my computer and sniff it, it is a CDC device. I use Hyperterminal to communicate with it, changing all the values I want. I would essentially like to simulate these commands with the Arduino. I have a USB-Host shield, but I would just like to make sure this will work before I attempt.

Thanks!

felis

CDC device is not very difficult to implement, here is an example for FTDI232, which is quite similar -> http://www.circuitsathome.com/mcu/towards-an-ft232-driver-for-the-usb-host-shield-part-0
/felis

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy