Pages: [1]   Go Down
Author Topic: Charging batteries in series in an Arduino Fio  (Read 1676 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 9
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi --

I've got an Arduino Fio that I'd like to use with two identical LiPo batteries wired in series. Can anyone see any problems with trying to charge the two batteries at once via the USB power on the board?
Logged

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 361
Posts: 17262
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes, I see a possible problem. Li-po cells need special charging circuits that start out as a constant current charging mode and then switch to a constant voltage mode to top off the charge. How do you propose to charge a 2 cell series connected li-po battery with USB +5vdc voltage? A two cell series connected Li-po battery, fully charged has a 8.4 vdc terminal voltage and should never be allowed to discharge below 6vdc.

Li-po are great batteries with the highest energy density per weight available. However they have special needs in charging and in prevent over-discharging. Ignoring their special requirements results in fire and/or dead cells.


Lefty
« Last Edit: January 30, 2011, 07:14:31 pm by retrolefty » Logged

Pages: [1]   Go Up
Jump to: