Pages: [1]   Go Down
Author Topic: My ADDICTION to building Atmel AVR/Arduino-compatible boards...  (Read 1796 times)
0 Members and 1 Guest are viewing this topic.
Pasig City, Philippines
Offline Offline
Newbie
*
Karma: 3
Posts: 35
I enjoy doing Simple Things!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Just using locally (Philippines) available parts, I've constructed 10 Atmel AVR microcontroller development boards, using stripboards. What is not pictured, is my 1st two Atmel AVR boards from ProtoStack (Australia).


And, believe it or not... I'm only doing this as a hobby...

Kuya Marc
Logged

I run Xubuntu Linux as my only computer operating system!
Windows does not run here; Only

North Yorkshire, UK
Offline Offline
Faraday Member
**
Karma: 104
Posts: 5531
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Just using locally (Philippines) available parts, I've constructed 10 Atmel AVR microcontroller development boards, using stripboards. What is not pictured, is my 1st two Atmel AVR boards from ProtoStack (Australia).


And, believe it or not... I'm only doing this as a hobby...

Kuya Marc

What do you do with them all? smiley-grin
Logged

nr Bundaberg, Australia
Offline Offline
Tesla Member
***
Karma: 121
Posts: 8458
Scattered showers my arse -- Noah, 2348BC.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Man that shows some dedication.

______
Rob
Logged

Rob Gray aka the GRAYnomad www.robgray.com

0
Offline Offline
Jr. Member
**
Karma: 1
Posts: 82
Uno momento
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I like #10 with the zif socket, good thinking.
Logged

Kuala Lumpur, Malaysia
Offline Offline
Full Member
***
Karma: 4
Posts: 176
Anything is possible
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I did a few of them on breadboard and uses the MAX232 and a USB-Serial converter... but it is kinda silly to convert the TTL from 5V to +/- 12V then back to 5V again...

I tried looking for the Nokia CA-42 locally at mobile phone shops...

Most of the shops give me a strange look... later I found out only very old Nokia models uses CA-42 cables...

End up using the DFR's FTDI Breakout board... would like a DIP version of USB-TTL but most of the USB-TTL are all surface mount chips..

Logged

Pages: [1]   Go Up
Jump to: