Pages: [1]   Go Down
Author Topic: New Product: Rugged Circuits Aussie Shield  (Read 2803 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Faraday Member
**
Karma: 16
Posts: 2855
ruggedcircuits.com
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Rugged Circuits is pleased to announce the Aussie Shield, a new shield for the Arduino Uno, Duemilanove, and Mega family of boards. This is the shield that sits "down under".


Like our Quick Shield, the Aussie Shield breaks out all 28 I/O pins (D0-D13, A0-A5, VREF, 3x GND, VIN, RESET, +5V, +3.3V) to quick-connect terminal blocks that accept 20AWG-24AWG bare wire.

The difference is that on the Aussie Shield the Arduino plugs in upside down. Use the Aussie Shield for easy breadboarding, swapping Arduinos in fixed lab or art installations, using stacking shields standalone without an Arduino, or cross-wiring shield pins.

--
The Rugged Motor Driver: two H-bridges, more power than an L298, fully protected
Logged

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 362
Posts: 17305
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Now where in the heck did my reset switch disappear too. And my pin 13 pin isn't working. Any how am I going to connect my USBtiny ISP programmer.  smiley-lol

Just teasing you. Nice layout.

Lefty
Logged

0
Offline Offline
Faraday Member
**
Karma: 16
Posts: 2855
ruggedcircuits.com
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

The reset switch is at the bottom right and the D13 LED pin is at the bottom left  smiley-cool

ISP programming...well, you'll have to pop the board off for that one.

--
The Quick Shield: breakout all 28 pins to quick-connect terminals
Logged

Pages: [1]   Go Up
Jump to: