Pages: [1]   Go Down
Author Topic: USB Host + Arduino + Unknown Video Board  (Read 1705 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Jr. Member
**
Karma: 0
Posts: 59
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey all,

I have an old video board, it boots up and runs a projector. But I want to remove all the setup portion (you have to control it with a computer, I have the commands that need to be sent). There is a setup process where you change how bright the screen is and the resolution you need to run it at.

Anyway, when I connect this thing to my computer and sniff it, it is a CDC device. I use Hyperterminal to communicate with it, changing all the values I want. I would essentially like to simulate these commands with the Arduino. I have a USB-Host shield, but I would just like to make sure this will work before I attempt.

Thanks!
Logged

Louisville, CO
Offline Offline
Full Member
***
Karma: 2
Posts: 174
Arduino rocks
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

CDC device is not very difficult to implement, here is an example for FTDI232, which is quite similar -> http://www.circuitsathome.com/mcu/towards-an-ft232-driver-for-the-usb-host-shield-part-0
Logged

/felis

Pages: [1]   Go Up
Jump to: