Go Down

Topic: Windows 7 (x64) Arduino UNO serial Xon / Xoff (Read 3912 times) previous topic - next topic

Jan 30, 2011, 11:13 pm Last Edit: Jan 30, 2011, 11:22 pm by fvdstrigt Reason: 1
Hi,
I am using Win7 (64bit) together with Aduino Uno, using Aduino 0022. Installation of USB/serial driver was succesfull. uploading etc. is working fine.
But when I am using the Xon/Xoff protocol on the installed COMx, I am receiving the Xon and Xoff characters in the used application. Because they are transmission control characters I think they should suppressed by USB driver.
Anyone having the same problem and/or solution?

cfc

Excuse this question: aren't we advised to use no flow control with Arduino and XBee's  ?

Maybe that's true. But I am not aware.
Just try to use an existing arduino uno project. It's specifying to configure xon/xoff on COMx.
Result: mentioned problems with win7 x64. As far as I understand other members of the project have no issues with 32bit systems.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy