Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: Windows 7 (x64) Arduino UNO serial Xon / Xoff  (Read 2580 times)
0 Members and 1 Guest are viewing this topic.
fvdstrigt
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
« on: January 30, 2011, 05:13:51 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Hi,
I am using Win7 (64bit) together with Aduino Uno, using Aduino 0022. Installation of USB/serial driver was succesfull. uploading etc. is working fine.
But when I am using the Xon/Xoff protocol on the installed COMx, I am receiving the Xon and Xoff characters in the used application. Because they are transmission control characters I think they should suppressed by USB driver.
Anyone having the same problem and/or solution?
« Last Edit: January 30, 2011, 05:22:54 pm by fvdstrigt » Logged

cfc
0
Offline Offline
Newbie
*
Karma: 0
Posts: 14
AVR today, ARM tomorrow(or so).
View Profile
« Reply #1 on: January 30, 2011, 10:14:33 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Excuse this question: aren't we advised to use no flow control with Arduino and XBee's  ?
Logged

fvdstrigt
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
« Reply #2 on: January 31, 2011, 07:29:01 am »
 Bigger Bigger Smaller Smaller Reset Reset
Maybe that's true. But I am not aware.
Just try to use an existing arduino uno project. It's specifying to configure xon/xoff on COMx.
Result: mentioned problems with win7 x64. As far as I understand other members of the project have no issues with 32bit systems.
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: