Go Down

Topic: stk500_getsync() attempt 1 of 10: not in sync: resp=0x56 (Read 472 times) previous topic - next topic

Anand_kumar

I am using FT232R breakout for serial communication, interfaced it with Arduino Pro(5V, 16MHz). I selected respective board in Arduino tool, I am using COM11 as serial port(I updated the ftdi driver as well). When I try to upload the code onto the Arduino Pro, I am getting this error as shown below. I have checked connections as well and everything looks good.

avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x56
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x56

avrdude done.  Thank you.

Problem uploading to board.  See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

Please suggest, I have checked out various posts but nothing worked out yet.

Thanks.

Arodd2000

I had this problem when I was using serial on pins 0 and 1, instead of software serial, and leaving the serial connection plugged in while I was trying to upload. You can also try reinstalling the IDE.

hammy

Try the loop back test to identify where your problem is .

Go Up