Pages: [1]   Go Down
Author Topic: Windows 7 (x64) Arduino UNO serial Xon / Xoff  (Read 3331 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,
I am using Win7 (64bit) together with Aduino Uno, using Aduino 0022. Installation of USB/serial driver was succesfull. uploading etc. is working fine.
But when I am using the Xon/Xoff protocol on the installed COMx, I am receiving the Xon and Xoff characters in the used application. Because they are transmission control characters I think they should suppressed by USB driver.
Anyone having the same problem and/or solution?
« Last Edit: January 30, 2011, 05:22:54 pm by fvdstrigt » Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 14
AVR today, ARM tomorrow(or so).
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Excuse this question: aren't we advised to use no flow control with Arduino and XBee's  ?
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Maybe that's true. But I am not aware.
Just try to use an existing arduino uno project. It's specifying to configure xon/xoff on COMx.
Result: mentioned problems with win7 x64. As far as I understand other members of the project have no issues with 32bit systems.
Logged

Pages: [1]   Go Up
Jump to: