Go Down

Topic: Arduino+Processing and Arduino+Grasshopper, advice? (Read 1 time) previous topic - next topic


I am working on a project where sensor data gathered via Arduino causes some movement in an installation. I am in the process of making the actual mechanical piece now but I would like to create a digital simulation of the built work too.
So sensor data would be collected via the Arduino and instead of moving a physical structure, it would move a digital image. This would be interactive in real time. I intend to project the resulting image. Any suggestions on the best way to do this? Should I interface Arduino with Processing? Arduino with Grasshopper? I haven't done either before so I am not sure which would be best.
Any opinions on which would be easier? which would produce a better results?
Any other advice would be so appreciated!


I would go with the arduino / processing combination as there are lots of examples of processing changing displays and it is easy to read the serial port for data from an arduino.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131