Go Down

Topic: PWM Controller (Read 1 time) previous topic - next topic


Using a DF-Robot motor shield to drive a hard disk voice coil, but it whistles when anything other than 100% PWM is applied.
Have played around with a bit of capacitor filtering, with marginal improvements.
Can anyone suggest a PWM controller chip I could use, that has a higher frequency than the PWM O/P of the arduino.
Have read a few posts about changing the frequency, but would rather buy a an purpose IC that can do the job.
Did an google and found SG3526 etc, but would be nice if someone had used a similar device already.


Found my answer that allows the PWM freq to be 100kHz

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131