Pages: [1]   Go Down
Author Topic: Newb to ARDUINO  (Read 463 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 1
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi guys I'm a newb to Arduino but I have experience with Atmel processors.  I like what I have seen so far but I have probably a few silly questions.  I'm use to in AVR studio setting up the uart but here it looks like in the examples that I have seen it is as simple as putting in the setup section Serial.begin for my own sanity sake I was wanting to look at the code behind this initialisation of Serial.begin but cannot find it.  Can anyone point me to where this is at?  Thanks.

nr Bundaberg, Australia
Online Online
Tesla Member
Karma: 129
Posts: 8600
Scattered showers my arse -- Noah, 2348BC.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Drill down into the folders under your Arduino-00XX installation and you'll find all the source codes.

Something like

program files>arduino-0021>hardware>arduino>cores>arduino>HardwareSerial.cpp

« Last Edit: February 04, 2011, 11:46:52 am by Graynomad » Logged

Rob Gray aka the GRAYnomad

Pages: [1]   Go Up
Jump to: