Pages: [1]   Go Down
Author Topic: Newb to ARDUINO  (Read 447 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 1
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi guys I'm a newb to Arduino but I have experience with Atmel processors.  I like what I have seen so far but I have probably a few silly questions.  I'm use to in AVR studio setting up the uart but here it looks like in the examples that I have seen it is as simple as putting in the setup section Serial.begin for my own sanity sake I was wanting to look at the code behind this initialisation of Serial.begin but cannot find it.  Can anyone point me to where this is at?  Thanks.
Logged

nr Bundaberg, Australia
Online Online
Tesla Member
***
Karma: 126
Posts: 8497
Scattered showers my arse -- Noah, 2348BC.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Drill down into the folders under your Arduino-00XX installation and you'll find all the source codes.

Something like

program files>arduino-0021>hardware>arduino>cores>arduino>HardwareSerial.cpp

______
Rob
« Last Edit: February 04, 2011, 11:46:52 am by Graynomad » Logged

Rob Gray aka the GRAYnomad www.robgray.com

Pages: [1]   Go Up
Jump to: