Go Down

Topic: Arduino upload problem (Read 7839 times) previous topic - next topic


i cant upload to my arduino ti says

avrdude: stk500_getsync(): not in sync: resp=0x30
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51


What type of board? (Deumillanove, UNO, MEGA)?
Are you sure you selected the right serial port and board in the IDE?
Is this a Arduino out the box or did it just start doing this?
Do the RX and TX lights do anything such as always off, always on or blinking?
Avoid throwing electronics out as you or someone else might need them for parts or use.
Solid state rectifiers are the only REAL rectifiers.
Resistors for LEDS!


And what operating system do you use? (eg. Windows XP, Ubuntu, mac, exc.)


Thanks for the replays but i had to change the serial port and now it works XD

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131