Go Down

Topic: Which bootloader to use (Read 1 time) previous topic - next topic

shelleycat

I'm using a minimal Atmega168 and a RS232-TTL converter, and wanted to set it up with a bootloader again (having erased the chip in a fit of experimenting with clocks).

Which one to use?  There are lots of them, and several say 168 in the name.
Does arduino-0021\hardware\arduino\boards.txt  specify the right one? 

or if not, which is the right one?

(Atmega168, 16Mhz crystal circuit)


retrolefty

#1
Feb 05, 2011, 07:36 pm Last Edit: Feb 05, 2011, 07:38 pm by retrolefty Reason: 1
In version 22 (I think also versions 20-22) of the arduino IDE, the third one down from the top should be the one you select. For version 19 then it's the second board listed.



shelleycat


Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview