Go Down

Topic: Setup / connection Arduino UNO -> Gyro Breakout Board - IXZ500 Dual 500°/s (Read 2610 times) previous topic - next topic

Hi everyone,

I am quite new to Arduino. I have searched the forum about Gyros, but only found code examples, so I am asking myself:

I have an Arduino UNO board and an Gyro Breakout Board - IXZ500 Dual 500°/s from which I want to read values. Since I am a programmer but not experienced in electronics, I don't really know how to connect the boards to get input (which pins to wire on the Gyro, do I need resistors etc.)

Does someone have some advice or even better, a scheme (Fritzing maybe?) This sure is very basic electronics stuff, but I am a bit stuck right now... :)

Thank you in advance!

Edit: if you think this question is stupid/lazy, please let me also know, right ;) thx!

Hi, I have found this very nice instruction:

http://wiring.org.co/learning/basics/gyroixz500.html

I did not know of this site, seems great!

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy